Sparkle ATX-400PA 400W 20/24pin SATA Power Supply

Specifications
• Mfr Part Number: ATX-400PA
• Features:
• Complied with ATX12V 2.0 standard
• High efficiency and reliability
• Remote On/Off function
• Internal 12V DC fan included
• Noise Killer (Thermal fan speed control function)
• Low noise and ripple
• Complies with FCC part 15 subpart J Class B and CISPR 22 Class B
• Output over voltage, short circuit, and over current protection
• 100% Hi-pot, ATE, and burn-in tested
• Re-settable power shut down
• Approved by UL 60950, IEC 60950, TUV EN60950, NEMKO (CB Report)
• Input:
• Input Range: ±10% of 115Vrms/57~63Hz, ±10% of 230Vrms/47~53Hz, manual selection
• Input Current: 10A (RMS) @ 115Vrms/60Hz, 5A (RMS) @ 230Vrms/50Hz
• Inrush Current: 120A max cold start, 150A warm measured at 115Vrms/60Hz
• Output:
• Total Output: 400 W
• +3.3V and +5V total output not exceed 150W
• +3.3V is load on 22A then +5V maximum load is 11.4A; +5V is load on 22A then +3.3V maximum load is 6A
• +12V1, +12V2 total output not exceed 348W
• +3.3V, +5V, +12V1DC, and +12V2DC total output not exceed 386W
• Dielectric Withstand: Input to frame ground 1800V AC for 1 second
• Efficiency: 70% minimum measured at nominal AC main voltage and frequency with maximum loads on all outputs
• Rise Time: Less than 20ms on all outputs
• Hold-up Time: 12ms minimum at nominal input voltage
• Power Good Signal: Power on delay time 100 ~ 500ms, off delay 1ms minimum (TTL and CMOS compatible)
• Leakage Current: Not exceed 3.5mA
• MTBF: 100,000 hours on maximum load at +25°C
• Cooling System: 1x 80mm Cooling Fan
• Connectors: 1x 24pin Main power connector; 1x 12V P4 connector; 6x Peripheral connectors; 2x SATA connectors; 1x Floppy connector
• Dimensions (WxLxH): 6 x 5.5 x 3.4 inch / 150 x 140 x 86 mm

* Product descriptions and part numbers are subject to change, and may not reflect manufacturer product changes. Please check the manufacturer's website and use the item's manufacturer part number to find the most up to date product description.