Sparkle ATX-300PA 300W 20/24pin SATA Power Supply

Specifications
• Mfr Part Number: ATX-300PA-B204
• Feature:
• Complied with ATX12V 2.0 standard
• High efficiency, low noise and ripple and reliability
• Remote On/Off function
• Internal 80mm 12V DC fan included
• Noise Killer (Thermal fan speed control function)
• Complies with FCC part 15 subpart J Class B and CISPR 22 Class B
• Output over voltage, short circuit, and over current protection
• 100% Hi-pot, ATE, and burn-in tested
• Re-settable power shut down
• Approved by UL 60950, TUV, IEC 60950, NEMKO (CB Report)
• Included On/Off Switch
• Input:
• Input Range: ±10% of 115Vrms/57~ 63Hz, ±10% of 230Vrms/47~ 53Hz, manual selection.
• Input Current: 7A (RMS) @ 115Vrms/60Hz, 4A (RMS) @ 230Vrms/50Hz
• Inrush Current: 80A Max cold start, 100A Max warm start measured at 115Vrms/60Hz
• Output:
• Total Output: 300W
• +3.3V and +5V total output not exceed 120W
• +3.3V is load on 20A then +5V maximum load is 10.8A; +5V is load on 20A then +3.3V maximum load is 6A
• +12V1+12V2 total output not exceed 264W
• +3.3V, +5V, +12V1, and +12V2 total output not exceed 286W
• Connectors: 20/24pin Main power; 4pin P4 power; 4x Peripheral; 1x SATA; 1x Floppy
• Dielectric Withstand: Input to frame ground 1800V AC for 1 second
• Insulation Resistance: 20 Meg. Ohm Min.
• Efficiency: 70% minimum measured at nominal AC main voltage with maximum load on all outputs
• Rise Time: Less than 20mS on all outputs
• Hold-up Time: 12ms minimum at 115V/230VAC
• Power Good Signal: Power on delay time 100 ms to 500 ms, off delay 1ms minimum (TTL and CMOS compatible)
• Leakage Current: Not exceed 3.5mA
• MTBF:100,000 hours on maximum load at +25°C
• Dimension (WxLxH): 6 x 5.5 x 3.4 inch / 150 x 140 x 86 mm

* Product descriptions and part numbers are subject to change, and may not reflect manufacturer product changes. Please check the manufacturer's website and use the item's manufacturer part number to find the most up to date product description.