Want an Eyefinity setup but don't want to spend $100+ for the DP-to-DVI adapter? Then this adapter is what you need. It works for resolutions up to 1920x1200 (single-link DVI connection), enough for 99.9% of people who want to run Eyefinity.
The setup may be a little confusing for some people. When I first plugged my monitors in, only two monitors came on although CCC showed three, with the one monitor's specs (plugged into DVI) not detected. I finally cloned my first monitor (on Displayport) with the 'off' one and then everything worked as expected.
You may or may not experience the same issue.
If your Displayport monitor flashes or blinks, check your cable and its length. Because this adapter is powered by the port instead of a separate USB plug, the timing signal (generated by the adapter itself and why Displayport, which doesn't need one, was chosen by ATI/AMD for the third output) may be a little weak. A longer/inferior quality cable may just have enough resistance to attenuate it even though it may work just fine from a regular DVI port.
Total reviews: 1
Review 1 - 1
Page 1 of 1 1
Note: Suggested item list is based on past customer purchase patterns and does not guarantee compatibility.
First time buying from SuperBiz, was a little hesitant due to lack of knowledge about them. Wow was I mistaken, as good as some of the other on-line merchants have been, these folks were super fast. I... (more)